SWELLPRO Splash Drone Auto, Руководство пользователя

Страница: 36 / 45

© 2015 SWELLPRO All Rights Reserved
36
4.6.4 Payload Release Installation
1. Screw out the seal nut from the bottom shell of the drone. You will see there is a screw hole.
2. Insert the Payload Release cable into the screw hole and screw in, make sure it well seal the
hole.
3. Find the proper location and fix the Payload Release under the 4 screw hole with screws
attached.
4. Insert the Payload Release cable into CH9 (SWA) of the receiver box.
4.6.5 Installation of FPV Waterproof Case
1. Screw out the seal nut from the bottom shell of the drone. You will see there is a screw hole.
2. Insert the Payload Release cable into the screw hole and screw in, make sure it well seal the
hole.
3. Take out the specified plastic shoe, fix it to the screw holes on the bottom of the drone with
the attached screws.
4. Fit the FPV waterproof case in the plastic shoe, tighten it with the screw bar.
5. Insert the USB AV cable into the camera, and insert the camera into the case, close it.
6. Adjust a proper angle for the camera, and insert the video cable into your VTX inside the
drone