SWELLPRO Splash Drone 3, Руководство по настройке, Страница: 10 / 17

10
[4] Six sides calibration button, click to start calibration.
Special note: to replace flight control, the user must calibrate the accelerometer.
If the following conditions occur, the accelerometer shall be calibrated again:
ü
In attitude stabilization model, the tilt angle of aircraft is larger when taking off;
ü
In attitude stabilization model, when hovering, the aircraft does not drift horizontally but
tilts instead of when only controlling the throttle lever.
ii. single side calibration
One side calibration accuracy is general, but easy to operate, recommended use.
Place the plane horizontally, click "Single side calibration", press the button, and finish the
calibration in 3 seconds, as shown below. If the aircraft placed tilt angle is a bit larger, or by
shaking, then need for recalibration.
iii. six surface calibration
The calibration accuracy is good, but the operation is complicated, so it is necessary to put
the six sides of the aircraft in order to complete the calibration. If the aircraft placed tilt angle
is a bit larger, or by shaking, then need for recalibration. Each step of the operation in the
software has related detailed graphic instructions.
Note: in order to ensure the accuracy of the calibration, in each direction the
colonel is punctual, please make sure that the flight control is calibrated on the
horizontal plane and that no tilt is allowed, otherwise recalibration is necessary.
It is recommended that the accelerometer be calibrated before the flight control
is fixed to the aircraft. After installed on the aircraft, calibration may require use
other tools to ensure calibration results.
e. Gyroscope (Compass) calibration
i. Interface profiles
The interface is used to calibrate the magnetic compass.