Sweiss SKYCUT 660, Руководство пользователя

Страница: 11 / 27

SWEISS
WELD.COM
info@sweissweld.com
9
Note when
these two functions toggling, check gas for 10 seconds and then stop it.
During this process, press and release the gun switch quickly, gas check finishes.
7. Positive output cable
connected to the work piece
8. Cutting gun connector connected to the cutting machine
9. Barometer
ensure there are no impurity and moisture in the compressed air
10. Compressed air output connector
11. Power switch
turn on or off the power source
12. Power cable connected to the appreciate power supply
4.2 Cutting Preparation
1) Tightly connect the power cable to electrical socket outlet (the input voltage, refer to the section 2
technology parameters)
2) Tonnect the air pipe to the air supply equipment, the earth cable to the workpiece
3) Turn on the power switch ,the power source lamp on.
4) Turn the RUN/SET switch to SET position, the air flow, then regulate the air pressure to 3.5-6bar
5) Turn the RUN/SET switch to RUN position, regulate the current after the flow stops.
6) Now all the preparation done .