Sweiss SKYCUT 660, Руководство пользователя

Страница: 9 / 27

SWEISS
WELD.COM
info@sweissweld.com
7
§3 Installation
3. 1 Unpacking
Use the packing lists to identify and account for each item.
1. Inspect each item for possible shipping damage. If damage is evident, contact your distributor and /
or shipping company before proceeding with the installation.
2. When using forklift, its arm length must be long enough to reach the outside to ensure lifting safely.
3. The movement may bring the potential danger or substantive hazard, so please make sure that the
machine is on the safe position before using.
3.2 Input Power Connections
Supply input connection of SKYCUT 660 power as shown in
the Fig3.1.
1. Check your power source for correct voltage before plugging in
or connecting the unit
2. Power Cord and Plug This power supply includes an input power
cord and plug suitable for 220V AC 3 - Phase input power.
3. If the power supply voltage continually goes beyond the
range of safe work voltage range, it will shorten the
welder life span. The following measures can be used:
Change the power supply input. Such as, connect the
welder with the stable power supply voltage of
distributor;
Reduce the machines using power supply in the same
time;
Set the voltage stabilization device in the front of power cable
input.
3. 3 Gas Connections
1. Connecting Gas Supply to Unit
Connect the gas line to the inlet port of the gas filter on the rear panel.
2. Check Air Quality
To test the quality of air, put the RUN / SET switch in the SET (down) position, check if there are any
oil or moisture in the air.
Live wire
Earth wire
3 380V Power
cable
Rear panel
Distrubutor
Earth wire
Live wire
Power
input
Power
switch
Power
cable input
Fig 3.1 the connect method of
the main supply