Swegon BlueBox Tau SKY Hi HP, Инструкция по установке, использованию и техническому обслуживанию

Страница: 37 / 88

37
We reserve the right to make changes without any prior notice. Translation from original instructions
6.3.3 Internal unit positioning
When provided, the internal unit must be installed inside the building. It must be wall-mounted using the support bracket
supplied with the unit. The place of installation must be dry, properly ventilated and duly lighted.
No volatile and/or corrosive substances and no flammable liquids or gas must be stored in the vicinity of the
unit.
The internal unit must be installed near the external unit at such distance that the max. length of the electric cables con-
necting the internal and external units is not exceeded. The min. installation distances of the internal unit (Fig. C.4) must
be complied with.
The wall must be capable of bearing at least 5 times the weight of the unit. If the wall is made of wood, wood screws must
be used in place of expansion anchors. Below is a description of the wall-mounting procedure.
1) Mark the wall-mounting holes of the bracket supporting the internal unit with a pencil. Make sure that the holes are per -
fectly aligned and the bracket is horizontal. Use a bubble level to check that the bracket is horizontal (Fig. B.6).
2) Drill the wall at the marked points using a drill and a suitable bit (Fig. B.7).
3) Fit the anchors in the drilled holes, secure the bracket to the wall, and make sure that the screws of the anchors are
properly tightened (Fig. B.8).
4) After mounting the bracket firmly, hook the internal unit up to the tabs in the bracket (Fig. B.9).
Considering the dimensions and weight of the unit, this operation must be carried out by two operators.