Swegon BlueBox Tau SKY Hi HP, Инструкция по установке, использованию и техническому обслуживанию

Страница: 32 / 88

32
We reserve the right to make changes without any prior notice. Translation from original instructions
5.7.2 Advanced controller (V6)
As an alternative to the base controller, this line of units can be controlled by a programmable microprocessor controller
featuring a user interface that comes in the form of an advanced touch screen control panel.
5.7.2.1 Switching the unit on/off
Normally, the units are shipped with standard programming for switching on and off from the keypad. The following in -
structions refer to this configuration.
Go to the controller display (Fig. B.3) and press the “ON/OFF” icon to switch the unit ON. Then press OK to confirm the
following message. The “ON/OFF” icon turns cyan to indicate that the unit is ON.
The unit actually gets started only if the remote ON/OFF digital input is closed.
Press the icon one more time to switch off the unit, followed by the OK button to confirm the following message. The icon
turns grey to indicate that the unit is OFF.
If time bands have been enabled, the unit switches on/off according to the time bands set in the unit.
5.7.2.2 Operating mode switching
Operating mode switching from cooling to heating occurs differently, according to the unit configuration.
If the unit is controlled according to the water temperature, tap the “MODE” icon to switch to a different mode and select the
desired operating mode among those featured.
If the unit is controlled according to ambient temperature, the operating mode is switched automatically, based on the tem-
perature in the room where the ambient temperature probe is installed.
5.7.2.3 Setpoint viewing and editing
If the unit is controlled according to the ambient temperature, the relevant setpoint is edited as follows: touch the value
alongside the “ROOM” icon and press the “+” and “-” buttons to edit the setpoint.
If the unit is controlled according to the water temperature:
• to view and edit the setpoint in zone 1, touch the value alongside the “ZONE 1” icon and press the “+” and “-” buttons
to edit the setpoint;
• to view and edit the setpoint in zone 2, touch the value alongside the “ZONE 2” icon and press the “+” and “-” buttons
to edit the setpoint;
• to view and edit the setpoint of domestic hot water, touch the value alongside the “DHW” icon and press the “+” and “-”
buttons to edit the setpoint.
If the unit is controlled according to the ambient temperature, the relevant setpoint is edited as follows: touch the value
alongside the “ROOM” icon and press the “+” and “-” buttons to edit the setpoint.