Swegon BlueBox Tau SKY Hi HP, Инструкция по установке, использованию и техническому обслуживанию

Страница: 35 / 88

35
We reserve the right to make changes without any prior notice. Translation from original instructions
6.3 Installation
The units are shipped from the factory already tested and only need electrical and hydraulic connections for installation.
6.3.1 External positioning
The external unit must be installed at a height of at least 200 mm from ground level. If the place of installation is snowy
and the possibility exists for snow to build up on the ground, the min. installation height specified in diagram C.2 must be
respected. A base frame option of adequate height is provided for this purpose. The frame is assembled as instructed below
(Appendix F).
Alternatively, a support frame (Fig. B.10) may be used having the features below:
• it must be flat, horizontal and capable of bearing at least 5 times the weight of the unit;
• it must be anchored to the ground;
• it must be capable of resisting wind-induced forces and moments;
• it must be at least 300 mm longer and wider than the unit;
• it must have a min. height of 200 mm from ground level in snow-free areas and 500 mm in snowy areas.
An alternative may be to use suitable wall-mounted brackets, provided that the brackets are horizontal and capable, to -
gether with the anchoring system and the wall, of bearing at least 5 times the weight of the unit.
Although the units transmit low levels of vibration to the ground, it is advisable to lay a strip of hard rubber between the base
frame and the support surface. If better isolation is required, it is advisable to use anti-vibration mounts.
In the event of installation on roofs or intermediate floors, the unit and pipes must be isolated from the walls and ceilings.
External units should not be positioned near private offices, bedrooms or areas where low sound emissions are required.
It is also advisable not to install the units in narrow passages or small spaces, in order to avoid reverberations, reflections,
resonances and acoustic interactions with elements outside the unit.
Units equipped with standard coils (copper-aluminium) should not be installed in an environment where there is an aggres -
sive chemical atmosphere, in order to avoid the risk of corrosion.
Special attention should be given to atmospheres containing sodium chloride, which make corrosion due to galvanic cur-
rents more likely to occur. Based on this, units with untreated coils must under no condition be installed in marine environ-
ments, close to animal farms or in highly polluted areas.
6.3.2 Base frame assembly procedure (option)
The base frame is supplied as an option for external unit installation. The dimensions (mm) of the base frame vary according
to the size of the unit:
- sizes 6-9-12: fig. F.1;
- sizes 15-19: fig. F.2.
The frame is adjustable in height and the value indicated with acronym AH shows the feet height adjustment range (mm).
The frame is supplied disassembled. The fitter is responsible for frame assembly. Below is a list of the frame components.
Component Quantity Notes
Rubber anti-vibration mount 4 Ø 60 mm with 2 threaded pins M8
Leg 2 -
Cross beam 4 -
Adjustable metal foot 4 Base, Ø 76 mm
Nut, M8 8 -
Bolt, M6x20 12 -
Expansion screws, M6x20 8 -
Spring washers, Ø 6 mm 12 -
Small flat washers, Ø 6 mm 12 External diameter, Ø 19 mm
Large flat washers, Ø 8.9 mm 8 External diameter, Ø 31.7 mm