9
6.1.1 Air inlet filter mats on machine housing:
Ultimate 2000 DMX uses two air filter mats covering all air in/outlets on the machine housing.
The filter mats protect the machine from dirt and dust. It is very important though, to clean or
replace the filter mats when clogged by dirt and dust. If not, the clogged filters will prevent a
sufficient air flow through the machine housing, which may cause internal mechanical parts
(i.e. the compressor) to overheat.
To ensure good performance and extended lifetime of compressor, fans and other expensive
components, check filter mats frequently. If dust or dirt is clogging the inlets, replace the filters
immediately. Do not use the machine if sufficient air flow cannot be guaranteed
Replacement of the filter mats is easy and can be done in a few minutes only. We suggest the
mats be replaced on a regular basis to ensure good functioning at all times. While doing this
we recommend general internal cleaning of machine housing as well as checking, and
replacing the following filters, if needed:
•
Air inlet filter mats, one covers front, left & right sides of machine housing, the second mat
covers the rear fan inlet.
•
Replacement of compressor’s air inlet filter cartridge.
•
Cleaning of the compressed air filter cartridge.
•
Cleaning of the nozzle unit (only necessary if haze output is low)
•
Cleaning or replacement of haze fluid filter
•
If necessary, empty and clean the fluid tank
NOTE: The filter mats are made with a special material that withstands the oil particles in the
haze surrounding the machine during operation. The size of the open cells in the filter material
is also tested for optimum performance, to ensure good airflow, preventing dust from coming
in to the machine housing. Using other open cell foam mats may cause problems. Damage to,
or overheating of, internal parts are NOT covered by manufacturer’s warranty if non-original
filters have been used.
The service bulletins contain a detailed description on how to perform the above service &
maintenance.
6.1.2 Ergonomic AluGrip
TM
handle:
Ultimate 2000 DMX is equipped with a new, ergonomic, AluGrip
TM
handle allowing one or two-
hand carriage. The handle is made with a solid aluminium profile to ensure strength and
lightweight. To ensure a safe grip, always keep the handle clean and free from oil residues to
avoid a slippery surface, which can be dangerous.
