swaploader SL-240, Руководство по эксплуатации и частям

Страница: 50 / 140

INSTALLATION INSTRUCTIONS
1. Review all directions and diagrams provided before starting bumper installation.
2. Trim truck frame to indicated dimensions (See Figure 1). These dimensions will facilitate the
mounting of the rear light assembly if it is also being mounted.
3. Measure the distance from the
bottom of the truck frame to the
ground (NOTE: This should be
performed on a level surface).
Based on this measurement and the
dimensions in Figure 1, the vertical
channel [Part No. 63H94] may
need to be modified in length to
meet the Office of Motor Carrier
Safety (OMCS) regulations.
Regulation 393.86 requires that no
bumper be located more than 30”
off the ground when the truck is
empty, and the end of the bumper
should not be located more than
24” from the extreme rear of the
vehicle, including truck bodies (See
Figure 2). Once the length has been
determined for the vertical channels,
weld them to the truck frame (See
additional notes on the next page).
4. Center the bumper weldment [Part No.
52H12] with factory installed extensions
Part No. 52H13] on the vertical channels
[Part No. 63H94]. Position rear of
bumper from rear of the hoist as
indicated by the bumper location chart.
This is crucial in order to ensure that the
container longsills do not contact the
bumper during the dump cycle (See
Figures 1 & 2).
5. Weld the bumper weldment to the
vertical channels (See Figure 1 & 3).
Figure 1
Figure 2