Installation Procedure
Disclaimer
This manual will give you basic instructions for the
installation of the product in a step-by-step sequence that
will work in most types of installations. If you have an
installation application that is not covered in this manual,
please contact Comfort Designs directly for additional
information about your application.
Follow all installation instructions. Failure to follow these
instructions could result in personal injuries, water damage,
or other damage to floors, pipes, walls, or other portions of
your building or home.
Trial Fit
It may be necessary to trim the edge of the vanity top to fit
snugly against the side wall. Install the trimmed edge against
the wall.
Faucet Holes
Note
: All Comfort Designs sinks are manufactured with one
predrilled hole. Optional locations for additional
holes are located on the underside of the sink using
marks (4” and 8”) which are molded into the sink.
Follow
Steps 6 and 7 for drilling additional holes to meet the
requirements of the sink faucet or other accessories.
VI-001
0”
4”
8”
Installation Procedure
1. If necessary, identify the location of additional holes for the
faucet or other accessories and drill a 1/4” pilot hole from
the back side of the sink.
To prevent damage to the unit, do not use an auger style drill
bit.
Breathing Hazard
When cutting or drilling, use a dust
collection method which prevents
dust particles from going into the air. Always work in a well-
ventilated area. To keep the area well ventilated, open
windows and use exhaust fans. Always use an OSHA
approved dust mask when cutting, drilling, or sanding.
VI-002
IMPORTANT NOTICE
VI-003
WARNING
Comfort Designs with Swan Solid Surface
6
800.443.7269