14
14
14
Playing Back Images and Videos
There are two ways to view images and videos captured by the RedAlert. One way
is to view them through the RedAlert (and the TV that the
RedAlert
is connected
to) and the other is to simply take the SD card out of the
RedAlert
, and insert it into
an SD card reader attached to your computer.
To Playback images/videos using the
RedAlert
:
Whilst in the live monitoring screen, press MODE to change to PLAYBACK
1.
MODE.
Whilst in PLAYBACK MODE, use the LEFT/RIGHT buttons to cycle between
2.
images in the current dated folder.
To play a video, select it and press the DOWN arrow to begin playback.
3.
To Change Folders:
Whilst in PLAYBACK MODE, press DISP to bring
up a list of folders.
Use the UP/DOWN arrows to select the dated
folder you wish to see, and press OK to select.
Note: Some dates might have multiple folders.
To DELETE unwanted images/videos:
Whilst in PLAYBACK MODE, select the image/
video that you wish to delete.
Press MENU to open the PLAYBACK MENU. The
PLAYBACK MENU has the following options:
Delete One:
•
Deletes the selected image.
Delete All:
•
Deletes all stored images.
Format:
•
Deletes all information from the
RedAlert, and repairs the fi le structure of
the SD card.
When you select one of these options, you will
be asked to confi rm your choice. Highlight the
GREEN TICK
to proceed, or highlight the
RED
‘X’
to cancel your choice.
7
About the
Wireless Camera
Your RedAlert may have come with the
Wireless
Camera
. If so, you’ll want to read this section on
how to install and use the
Camera
. Also, see the
section on page 11 on how to get the best results
from it.
The
Camera
is a weather resistant, analog wireless
camera. It captures color images by day and black
& white at night using its built-in infrared LEDs.
Remember:
the
Wireless Camera
needs to be
connected to power via the supplied power adaptor.
The term ‘wireless’ refers to there being no cable
between the
Camera
and the
RedAlert.
Installing
Wireless
Camera
1. Select the position for your camera
You can attach the camera to power and, if the
RedAlert
has already been attached
to a TV, check both the cameras view and the level of interference at the same time
(see page 11 for more information on wireless interference).
2. Mount the camera
Use an appropriate screw type for the surface your mounting the camera to. Make
sure the lens is upright relative to your subject - you can tell easily as the antenna
should be relatively upright.
3. Connect the camera to power via the supplied power adaptor
4. Set the camera’s channel
The
Wireless Camera
can transmit its images on one of four channels. To set the
channel:
Unscrew the front of the camera
1.
case.
Locate the 2 dip switches near the
2.
lens - they are located
Using a toothpick or similar, fl ip the dip
3.
switches to the desired confi guration,
as listed.
Channel 1
Channel 3
Channel 2
Channel 4
Dip Switches
