Swagelok CWS-D100-1B, Руководство пользователя

Страница: 136 / 277

Maintenance
CWS − D100 − B Welding System

2005 ‘ Swagelok Company, all rights reserved
September 2005
6-8
Rotor
To disassemble the rotor, follow these steps:
1. Remove the rotor screws and the electrode clamping
plate screws from the rotor. Remove the electrode from
the ceramic insert. See Figure 6-14.
2. Place the rotor on a clean, dry surface with the rotor
opening facing up. Separate the gear ring from the
brush ring enough to clear the two rotor pins.
See Figure 6-15.
3. Completely separate the gear ring from the brush
ring as shown in Figure 6-16. Lay the rings flat on
the work surface.
4. Remove the ball bearings from the gear and brush rings.
See Figure 6-16.
5. Inspect the ball bearings for wear and damage. Replace
if necessary.
6. If the ball bearings are dirty, clean them with a mild
solvent or cleaning solution. Dry the balls thoroughly.
Figure 6-14 Removing the Rotor and
Electrode Clamping Plate Screws
Rotor
Rotor Screw
Electrode
Clamping
Plate Screw
Remove
Electrode
Figure 6-15 Placing the Rotor on the
Work Surface
Opening
Brush
Ring
Gear Ring
Rotor Pin
Location
Rotor Pin
Location
Figure 6-16 Separating the Gear Ring
from the Brush Ring
Ball
Bearing
Gear Ring
Brush Ring
Separate
Rings
Caution!
Do not use a flammable
liquid to clean the ball
bearings.