SW-Stahl 32229L, Инструкция по эксплуатации

Страница: 17 / 20

SW-Stahl und Werkzeugvertriebs GmbH Tel. +49 (0) 2191 / 46438-0
Leverkuser Strasse 65 Fax +49 (0) 2191 / 46438-40
D-42897 Remscheid E-Mail: info@swstahl.de
32229L
www.swstahl.de
BED
IENUN
GS
AN
LEI
TUNG /
INSTRUC
TI
ON MANU
AL
Таchometer
Тhe tachometer is used to measure the engine speed. The engine speed must be
known in order to:

adjust the idling speed

check the ignition

adjust the timing

check the adjustment
1.
Press the tact switch to light the RPM indicator.
2. Connect the inductive pick-up to the first cylinder.
3. Connect the red clip to the positive battery terminal (+) and the black clip to the
negative battery terminal (-). (See figure 1).
4. Start the engine and read the RPM from the display. Compare the RPM reading
with the figure recommended by the vehicle manufacturer. Should any deviations
be found, mark appropriate adjustments.
Voltmeter
The voltmeter can be used to check the battery voltage and the supply voltage to
various electronic devices, e.g. lamps, etc.
1.
Testing of battery voltage under starting current load.
a.
Disconnect the ignition by pulling the plug off terminal 1 (1,D,RUP,-) on the
ignition coil.
b. Press the tact switch to light the VOLT indicator.
c. Connect the black clip to the negative battery terminal (-) and the red,
green clips to the positive battery terminal (+).
d. Start the engine by another person.
e. Read the voltage from the display.
NOTE: If the battery voltage is less than 9V, strongly recommend to ask a professional
technican to check the car battery again.
2.
Testing of a car battery on loading (e.g. lamps).
a.
Connect the black clip to the negative battery terminal (-) and the red clip
to the positive battery terminal (+).
b. Connect the green clip to the positive terminal of the loading device.
c. Switch on the device and read the voltage from the LED display.
NOTE: If the voltage is too low, this hints there is leakage through the respective leads
or connections. This is frequently happened by heating of connecting terminals, switches
or parts of the leads.
NOTE: When the voltage drops greater than what specified in your owner's manual,
strongly recommend to ask a professional technican to check this again.