Sven ROYAL 2R, Руководство по эксплуатации

Страница: 17 / 20

Operation manual
ENG
ROYAL 2R
17
7. INSTALLATION
All components should be switched off before connection.
Connection to the sound source
• While connecting a sound source, use only RCA-jacks. Make sure that the left and right channels are correctly
connected. Put the left RCA connecter into the left (white) jack of the amplifier, and the right RCA connecter – into the right
(red) jack of the amplifier. Connect the mini-jack connector to the stereo input jack of your sound card or music player.
• Please connect correctly the marked «left» jack to other marked «left» plug of other components.
Fig. 5. Sound source connection
Loudspeakers Connecton
• Don’t short-circuit the acoustic cable connectors.
•
Always observe polarity.
• For better contact of the cable connectors with terminals, strip about 10 mm of insulation and twist it as shown in the
picture below.
• To connect the cable, undo the clamp or unscrew the terminal and insert the cable end, then screw it on.
8. OPERATION GUIDE
Speaker Amplifier Switch-on
• Connect the power cable to the power socket, switch on the system on the left speaker rear panel. The same switch is
used to switch off the system.
Master and Timbre Volume Control
• Press the «Function» button once, twice or three times, the front panel LED will change from Green, Orange, and
Red color respectively.
• Press the Function button once, and the LED will light up green. Use
i
VOL- and
j
VOL+ buttons to adjust the master
volume level.
• Press the Function button twice, and the LED will light up orange. Use
i
VOL- and
j
VOL+ buttons to adjust the bass level.
• Press the Function button three times, and the LED will light up red. Use
i
VOL- and
j
VOL+ buttons to adjust the
treble level.
• If the Function button is pressed for more than three seconds, the volume and timbre settings will be cancelled, and the
sound will depend on the input signal only. The MSS settings can be also made with a remote control.
Fig. 6. Speakers connection