ENG
3
User’s Manual
•
Do not use the device in rooms where there may be vapors of flammable substances in the air.
Attention! To prevent the risk of fire or electric shock, avoid contact with water and operation in high
humidity environments. Do not use the appliance near bathtubs, sinks or other containers filled with
water.
•
Do not immerse any part of the appliance in water or other liquid. Do not operate the appliance with wet
hands. If the appliance gets wet, unplug it immediately.
•
In the event of the device falling into the water, unplug it immediately. In this case, in any case, do not put
your hands in water. Do not use the appliance after a fall if there are visible signs of damage. Before use, the
device must be checked by a qualified technician.
•
To power, the device, use a power grid with proper specifications. The power supply voltage must
correspond to the data indicated on the device panel.
•
The device can only be connected to a grounded network. To ensure your safety, grounding must be in
accordance with the electrical requirements. Do not use non-standard power supplies or connected devices.
When using an extension cord, make sure it is grounded.
•
Before switching on the device, make sure that the switch is in the OFF (О) position.
•
Do not carry the device by holding it behind the mains lead. It is also prohibited to disconnect the device
from the network by holding it behind the mains lead. When disconnecting the device from the network, hold
on the plug.
•
Avoid hanging the cord through the sharp of the table or touching it on heated surfaces.
•
After use, never wind the power cord around the device, as over time this can lead to a broken wire. Always
smoothly straighten the wire during storage.
•
Do not operate the kettle with a damaged power cord, as well as in cases where the normal operation of the
product is disturbed, if it has been applied or has been damaged in any other way.
•
Do not use the kettle outdoors.
•
Do not repair the kettle yourself. Repairs should only be carried out by qualified service personnel. Never
open the device on your own – this can cause an electric shock, lead to the failure of the device and voids the
manufacturer’s warranty.
•
Only original spare parts can be used to repair the device.
•
Any incorrect use of the product will void the warranty.
4. SPECIAL SAFETY INSTRUCTIONS FOR THIS DEVICE
•
Use the kettle only to heat the water. Never fill the kettle with the other liquids.
Never turn the kettle on without water!
Attention!
Your kettle is equipped with an overheating protection system. If there is no or little water in the
kettle, it will automatically turn off in case of overheating. If this happens, you must wait at least half an hour to
cool the kettle, after which you can pour water.
•
Pour only cold drinking water into the kettle.
•
Shipping equipment is permitted only in the original container.
•
Do not place the kettle near the walls, in the corner of the room, under overhanging panels or kitchen
cabinets, avoid falling and hit by foreign objects.
•
Place the kettle on heat-resistant, dry, hard and level surfaces.
•
Do not place the kettle near gas and electric stoves, or ovens.
•
Do not fill the kettle above the
max
mark and below the
min
.
•
Dangling cords can cause accidents, especially if children are pulling on the cord. It is recommended to put
the kettle on the work surface as far as possible from the edge of the table / work surface.
•
Ensure that the lid of the kettle is tightly closed during heating. Do not open the lid while water is boiling. This
can cause burns.
•
Never pour water into the kettle when it is on the stand.
•
Do not touch the body of the kettle (as it gets warm after switching on), and do not hold your hands over the
steam coming out from under the lid. Take the kettle only by the handle.
•
Pour water out of the kettle gradually. Remember that inside is boiling water.
•
Do not use the device if the kettle, power supply, wire or plug is damaged.
KT-G1806
