5. INSTALLATION
1. Connect loading to output AVR NEO R.
2. Connect AVR to utility power 220VAC
3. Switch On the AVR. Switcher Indicator, «Overload» , «Line» will light and self-testing begin. During the self-testing
Switcher Indicator, «Overload» , «Line» will light. When self-testing finish «Overload» , «Line» will light out.
4. After 10 second self-testing, indicator «Overload» will go out and indicator «Line» will be lit and a voltage will be connected
to target sockets. If indicator «Overload» after testing will not go out to maintain the stabilizer it is forbidden
5.At job of the AVR boost or buck of an entrance voltage indicator «Stabilization» will be shone
6. In case of an overload or short circuit the AVR will disconnect of a voltage. After elimination of the reason of
an overload the stabilizer is necessary for switching on again.
7. Avoltage on an input from above 270 volt the AVR will be disconnected. Thus indicator «Overload» will be shone.
6. TROUBLESHOOTING
Situation
Check Items
Solution
The AVR does not work.
1. Is the power switch on?
2. Is the voltage in the utility power socket?
3. Too much loading is connected to
the AVR.
1. Press main Switch on.
2. Be convinced available
an entrance voltage.
3. Disconnect some loading.
The indicator «overload» does not die
away and there is no target voltage.
1. Failure of the scheme of testing.
2. The AVR is faulty.
3. An entrance voltage too high.
Switch-off and anew switch on the
AVR. If the problem is not eliminated it
is necessary to address in the service
center.
The AVR often clicks, thus indicator
«Stabilizer» lights up.
The entrance voltage is very instability.
It is normal. The AVR adjusts
a target voltage.
The AVR has disconnected loading.
The indicator «Overload» is shone.
An INPUT voltage too high/low.
When the input voltage becomes normal
(170—270 VAC) the AVR will work.
7. SPECIFICATIONS
Specification/model
NEO R 500
NEO R 850
Maximum load
500 VА/280 W
850 VА/450 W
Protection
Over current, short circuit, overload, against a lightning
Surge energy rating
320 J
Indicators
LEDs indicating Output off, Normal, AVR
Input EURO
socket
Output
2 pc EURO socket
2 pc EURO IEC 320
Operating environment
0—40 °C, 10—90 % Rh, non condensing
Agency Approval
CE, RusTest
Input Voltage Range
170—270 V
Output Voltage Range
198—238 V
Frequency 50/60
hz
Weight, kg
1.42
1.85
Dimension, mm
118 х 112 х 106
124 х 124 х 119
Cable length, m
0.6
0.6
Notes:
1). This manual is provided «as it is», without any warranties, either express or implied. The supplier and its distributors are not
liable for any error, correctness, accuracy and reliability of the information, either express or implied, herein contained.
2). The manufacturer and its distributor are not liable for any direct, indirect, incidental, consequential, loss of business
profits, punitive or special damages, even if it and its suppliers have been advised of the possibility of such damages.
Durability — 5 years.
Eng
NEO R 500/850
7
