SVAT VIS300-7M2, Инструкция по эксплуатации

Страница: 7 / 18

SVAT ELECTRONICS
now you can see
WIRING INSTRUCTIONS
Connecting the Camera
– Note: You will need a philips head screwdriver
• Loosen the screw to the camera’s positive connection (marked 1) by
turning the screw counter clockwise.
Note: Do not fully unscrew the screw, just loosen it
enough to fit the horseshow end of the 50ft wires.
• Slide the Horseshoe end of the BLUE wire (marked 1)
underneath the Screw Terminal on the camera’s positive
connection (connection 1).
• Tighten up the screw to lock the blue wire into place.
• Loosen the screw to the cameras negative connection
(marked 2) by turning the screw counter clockwise.
Note: Do not fully unscrew the screw, just loosen it
enough to fit the horseshow end of the 50ft wires.
• Slide the Horseshoe end of the Brown wire (marked 2)
underneath the Screw Terminal on the camera’s negative
connection (marked 2).
• Tighten up the screw to lock the brown wire into place.
Connection 1 (Recommended)
Connecting the Monitor to Camera - Note: You will need a small
flat head screwdriver
• Using a screwdriver or similar object push down on the small
grey box above the hole marked as 1.
• Insert the available end of the blue wire into the monitor’s
positive camera connection (marked 1) and make sure it is
completely inserted.
• Release the downwards pressure on the grey box and this
should lock the wire into place.
6