SVAT VIS300-7M2, Инструкция по эксплуатации

Страница: 11 / 18

SVAT ELECTRONICS
now you can see
Complete all wiring before mounting the camera.
Angled Camera Mount – Must be Mounted BEFORE Flat Mount
The VIS300-7M2 has two identical angled mounts included with it so that you can place your camera on a twenty
degree angle or a 40 degree angle. This will make the camera angled towards the door instead of straight ahead.
This may or may not be necessary for your application.
If using one angled mount: (twenty degrees)
1. Lift up sticker located on the front of the camera on right side.
2. Completely remove the screw from the flat camera mount.
3. Remove camera from flat mount (it is held in by plastic tabs, you may have to apply some force to separate
the two pieces).
4. Locate a desired mounting location.
5. Pull wiring through the center hole on the angled mount.
6. Screw the angled mount into desired area near front entrance.
7. Screw the flat mount onto the angled mount by using the two protruding screw holes located on the angled
mount.
8. Reconnect the wires to the proper terminals (instructions above) and tighten the securing screws to secure
the wires to the back of the camera.
9. Put camera into the mount and insert the screw into the hole behind the sticker, tighten the screw to secure
camera to the mount.
10. Peel the paper off the back of the rest of the sticker in front and secure it over the screw hole.
If using two angled mounts: (40 degrees)
1. Lift up sticker located on the front of the camera on right side.
2. Completely remove the screw from the flat surface mount.
3. Remove camera from flat surface mount (it is held in by plastic tabs, you may have to apply some force to
separate the two pieces).
4. Locate a desired mounting location.
5. Pull wiring through the center hole on the angled mount.
6. Screw the angled mount into desired area near front entrance.
7. Place second angled mount over the first angled mount with the open area facing outwards. (in same
direction as the first angled mount).
8. Pull the wiring through the center hole of the second mount.
9. Secure the two mounts together by screwing a screw through the small holes located on the bottom and
top of the second mount.
10. Screw the flat mount onto the angled mount by using the two protruding screw holes located on the
angled mount.
11. Reconnect the wires to the proper terminals (instructions above) and tighten the securing screws to secure
the wires to the back of the camera.
12. Put camera into the mount and insert the screw into the hole behind the sticker, tighten the screw to secure
camera to the mount.
13. Peel the paper off the back of the rest of the sticker in front and secure it over the screw hole.
Make sure camera is at the average face level (145 cm – 160 cm from ground
CAMERA INSTALLATION AND OPERATION
10