SVAT VIS300-7M2, Инструкция по эксплуатации

Страница: 13 / 18

SVAT ELECTRONICS
now you can see
Chroma: Adjusting the Chroma knob will allow you to adjust the intensity of the color in
the picture on the monitor. The higher you adjust, the more intense the color will be.
Brightness: Adjusting the brightness will make the picture brighter or darker on the monitor. The
brighter it is where your camera is, the lower you should adjust the brightness.
1. To operate the camera, press and release the doorbell button on the camera.
2. The chime will ring on the inside monitor and the monitor screen will display the audio and video from
the camera.
3. To communicate from the monitor to the camera press and release the “Talk” button. Note: Audio from the
monitor will not be heard on the camera until the “Talk” button is pressed on the monitor.
4. Press and hold the “Unlock” button to trigger the electric doorstrike (IF INSTALLED) and allow the visitor to
enter. (A 12 V AC compatible electric door strike (not included) must be properly connected).
Automatic Monitor Time Out
The monitor will automatically stop displaying the audio/video at set intervals depending on the situation.
- If the doorbell is pressed and no other buttons are pressed the monitor will shut off after 55 seconds.
- If the view button is pressed the monitor will shut off after 40 seconds.
- If in view mode and the “Talk” button is pressed the communication and the monitor will stay on for
120 seconds.
GENERAL INFORMATION
12
BUTTON OPERATIONS CONT....
No Picture/Signal • Make sure all the connections are secure and properly connected
• Make sure your monitor is plugged into a power source from the
AC15V adapter on the back of the monitor
• Make sure there is nothing obstructing the view of the camera
Note:
that the camera will not appear on screen until someone
presses the doorbell or you press the view button yourself.
Picture to Bright/Dark
• The night vision comes on automatically when the light levels
drop; try the camera in a pitch black setting. The area that the
camera is in may get too much light to activate the sensor.
No Audio • Make sure the volume notch on the monitor is turned up and that
nothing is interfering with the speakers or microphone on the
monitor, or the camera
• If the melody is not playing, make sure nothing is interfering with
the speaker and try adjusting the melody volume to a
higher level
• Make sure whatever you are trying to hear is close enough to the
microphone on the camera/doorbell device
• Disconnect and reconnect the wires from the camera and the
monitor to make sure they are secure.
TROUBLESHOOTING