CV502-4CH
8
SVAT ELECTRONICS
now you can see
1. Press Menu.
2. Enter password if prompted. The default password is 123456.
3. Select NETWORK SETUP.
4. Make sure the “IP Mode” is set to DHCP. This setting is acceptable for
most users.
• If the IP mode is not set to DHCP, use the drop down list next to
type and change the type so that it is set to DHCP. You must hit
“apply” and “exit” for the DVR to restart and retrieve an IP address
5. Write down your IP address, port and DNS. This information will be
used in the next few steps to view the DVR on your computer as well
viewing the DVR over the Internet.
Finding your DVR’s IP Address
By default, the DVR IP mode is set to DHCP. This means the DVR will
automatically retrieve an IP address from the router that it is connected
to. Unless your network requires a static IP address leave the DVR IP mode
set as DHCP.
→
ONCE ACQUIRED,
YOUR IP ADDRESS
WILL APPEAR HERE
Note: If your router does not support DHCP, contact your
network administrator to supply you with the proper IP
information. If the DVR needs to store PPPoE (DSL/ADSL)
settings contact your ISP (Internet Service Provider) for the
proper IP address settings.
Preparing Your Computer for Viewing the DVR:
NETWORKING GUIDE
Every computer that is accessing the DVR will need to be configured to
download and run ActiveX controls. This change only needs to be made one
time on the computer that is accessing the DVR. This can be done by following
either of the two methods below. Method 2 only affects web sites that you
specifically add to the trusted sites list. To change for all web sites, use
Method 1. (Methods on following pages)