OPERATION INSTRUCTION
continued
• Use the directional key to move small yellow block selection. When 4 points of yellow
block are produced there will be q region wet up for the coverage setting area.
Time insert
: "On, Off" are the 2 different status settings. Use the cursor to select and press
[Enter] to confirm this function. While "On" selected, a system clock will be shown while
recording.
A-7
Housing Setting:
Highlight and select
Housings
, then press [Enter]for the selection, the sub-menu will shown
(as below), then select the required area.
Protocol
: Using the cursor to select and press [Enter]to confirm difference protocol
(pelco-d/p/02-15 etc.);
BaudRate
: Using the cursor to select and press [Enter] select difference rate at
1200/2400/4800/9600;
No
: Using the cursor to select and press [Enter] select difference housing number at
(01~63).
A-8
Network Setting:
Highlight and select
Network
, then press [Enter] for this selection, the sub-menu will be
shown (as below), then select the required area.
• IP Address:
Use the cursor to select and press [Enter]to enter the IP address.
• Subnet mask:
Use the cursor to select and press [Enter]to enter the subnet mask at
current location.
• Default Gateway:
Use the cursor to select and press [Enter] select default gateway
according to current IP address.
• Transport protocol:
Use the cursor to select and press [Enter] select.
A-9
Language Setting:
Make sure that English is the default setting.
GENERAL SETTINGS
Record Settings
Timer Record
Motion Detection
Alarm Record
Channels
Housings
Network
Language
Exit
Housing Settings
Channel Protocol
BaudRate
No.
1
pelco-d
1200
01
2
pelco-p
2400
10
3
enkel
4800
25
4
ccr-20g
9600
63
Return
GENERAL SETTINGS
Record Settings
Timer Record
Motion Detection
Alarm Record
Channels
Housings
Network
Language
Exit
Network Settings
IP Address:
029, 010, 001,100
Subnet mask:
255,255,255,000
Default gateway:
029,010,001,254
Transport protocol:
TCP/IP
Return
