Svarog ARC 160-PFC, Руководство пользователя

Страница: 16 / 29

Chart3: The preset current under LIFT TIG mode
c)
5 seconds later after setting the welding parameters, the
【
multifunctional data display
】
would flashes for one time, which means the data has been saved. Moreover, the panel
would display these data when restart the machine next time if the parameters keep
unchanged.
d)
When the input voltage is 95V~180V, the current adjustment range is 5A~110A.And when
the input voltage is 180V~265V, the current adjustment range is 5A~160A.
Note
：
The machine adopts touched ignition way when perform welding under TIG mode.
Firstly make sure the tungsten contacts the workpiece completely, then press the torch
switch, lifting up the torch to ignite arc successfully.
 Malfunction display
a) Malfunction display of over-current
The panel displays as Chart 4 when over-current, and the
【
multifunctional data display
】
flashes
continuously, the machine can not work normally. Restart the machine, the panel would display
the parameters that were set before malfunction occurrence.
Chart 4 ： Malfunction display of over current
14