Monitoring Station SV 279 PRO
12
Note: Communication of controller or SVAN 979 with a PC requires installation
of the USB drivers on your PC. USB driver for Svantek devices are available on
http://svantek.com/support-drivers-software.html
Note: Before starting upgrading be sure that your + software is Off! If
not, please Exit it before starting any upgrading.
To upgrade the firmware of the controller go through the next steps:
1. Switch off SVAN 979 and wait until all LEDs are off.
2. Connect the controller to the PC with SC 56 cable.
3. Run the
“file2usb.exe” file on the connected PC. The
BAT 1
LED will start
flashing a green colour.
4.
After “Success” is registered on the PC, disconnect the SC 56 cable.
Note: In case of any problems with the upgrade, switch off SVAN 979 and wait
until all LEDs are off, then extract the controller from the case and repeat steps from 2
to 4.
2.1.3. SP 270 - 3G modem
The 3G modem (
SP 270
) provides fast data
transfer over the Internet to a PC with standard
Internet connectivity. A 3G modem type
“GeMalto
®
EHS6 Terminal
” is used.
GeMalto
®
EHS6 Terminal uses mini-SIM cards
25mm x 15mm with Internet Access. The SIM slot
accepts 1.8V and 3V SIM cards in accordance
with GSM 11.12 Phase 2.
Note: See also GeMalto
®
EHS6 Terminal user manual.
The SIM-card is inserted with the circuit side
facing left in the slot pushing it until it snaps hold.
