Suzuki SY419, Дополнительное руководство по обслуживанию

Страница: 61 / 240

INSTALLATION
1) Install swirl chambers, so that swirl chamber protrusion en-
gages cylinder head recess.
2) Reverse removal procedure.
1. Swirl chamber
2. Protrusion
PLUG BALL
There are 6 plug balls in cylinder head.
Their locations are indicated in left figure.
1. Plug ball 9.5 mm
2. Plug ball 7.9 mm
INSTALLATION
1) Apply “LOCTITE 243” on the plug ball.
2) Push the plug ball into the cylinder head with special tool (A) and
(B) until the bottom of (A) is in contact with the top of (B).
Special tool
(A), (B) and (C): 09918-96510/OUT0000136
1. Cylinder head
2. Plug ball
SECOND PLUG BALL
If oil leaks from plug ball 9.5 mm, insert a second plug ball over
original ball.
If oil leaks form plug balls 7.9 mm, replace cylinder head with new
one because no second ball is not available.
1. Plug ball 9.5 mm
2. Plug ball 7.9 mm
INSTALLATION
1) Push plug ball into cylinder head with special tool (A) and (C)
until the bottom of (A) is in contact with the top of (C).
2) Apply “LOCTITE 243” on the second plug ball.
3) Push the second plug ball into the cylinder head with special
tool (A) and (B) until the bottom of (A) is in contact with the top
of (B).
1. Second plug ball
ENGINE MECHANICAL 6A4-11