12
(A)
Groove/scarf
7. CLEANING
CAUTION: Switch off the main switch before cleaning. Pay attention to your hand when in close the
cloth feed table and remove or set the waste saucer.
To use the machine with best condition for long time without some trivial problem, you should clean the
machine daily after operating. Important areas are around loopers/spreaders, bottom of the machine
base, cloth feed table and knife/cutting block. Clean up the hole of knife and the hole under the knife
once a week at least to prevent a knife broken.
How to clean up under the table : Raise the cloth feed table
①
, collect a fabric chips with brash and drop
under the base and weep them or vacuum. After cleaning, place it to the original position anytime
when the machine ready for start.
NOTE: Never use a compressed air for cleaning in order to avoid some problem that a small fabric chips
go into the important parts such as main cam etc.
①
Raise
the table
Hole
8. NEEDLE
CAUTION: Switch off the main switch before changing.
Needle system of your machine is “SCHMETZ system 558” size #90 ~ #120. Never use over size #120 to
the machine. The machine is adjusted and equipped with size #90 or #110 at the factory.
Model SE200-MS is adjusted and equipped with size #90 for medium material sewing
Model SE200-MJ is adjusted and equipped with size #110 for heavy/jeans material sewing
When changing the needle size (for example; #90
→
#120 or #120
→
#90), you are requested to readjust
the position of loopers, spreaders and needle guard because the thickness of needle is different depend on
the needle size. If you changed the needle size from #90 to #120 and operated the machine without
readjust the position of those parts, the needle would hit those parts. The worst case is that those parts
will be broken or skip/jump stitch will happen. Please contact your agent when you wish to change.
To replace the needle, loosen the screw (A) and
remove the old one. Insert a new one into the
hole of the needle bar as deep as possible. When
the machine is the start position, the
groove/scarf of needle should be in the direction
of your side.
Looper/Spreader etc.
Knife