Suzuki RM 250 2003, Руководство по эксплуатации для владельца

Страница: 15 / 225

1-10 GENERAL INFORMATION
STOPPING THE ENGINE
1) Shift the transmission into neutral.
2) Turn the fuel valve lever to the “OFF” position.
3) Push the engine stop switch
2
to stop the engine.
TRANSMISSION
This motorcycle has a 5-speed transmission. Neutral is located
between low and 2nd. Engage first gear by pressing the lever
down from the neutral position. You can shift into higher gears
by lifting on the shift lever once for each gear. When neutral is
desired, press or lift the lever to the position halfway between
low and 2nd gear.
BREAK-IN (RUNNING-IN)
WHEN THE MOTORCYCLE IS NEW
1) Warm up the engine before starting off.
2) Ride for 1 hour using less than 1/2 throttle opening with vari-
ous throttle opening.
3) Ride for 1 hour using less than 3/4 throttle opening with vari-
ous throttle opening.
NOTE:
* The break-in (running-in) period is the period of greatest wear.
* The bolts and nuts of the new machine can loosen quickly. Be
sure to retighten the bolts and nuts during the break-in (run-
ning-in) period.
WHEN ENGINE PARTS ARE REPLACED
Follow the same procedure when any of the following parts are
replaced:
Piston
Piston ring
Cylinder
Crankshaft
Crankshaft bearing
!
WARNING
Leaving the fuel valve in the “ON” position may cause
carburetor overflow. This can cause a fire or severe
engine damage when you start the engine.
Always leave the fuel valve in the “OFF” position
when the engine is not running.
N