Suzuki Nexa S-CROSS series 2015, Инструкция по эксплуатации и сервисная книжка

Страница: 112 / 288

23(5$7,1*<2859(+,&/(
06(
tion. In this case, always let the engine
idle before stop it.
6WDUWLQJD&ROGDQG:DUP(QJLQH
&ROGHQJLQH
Depress the clutch and brake pedals fully
and press the engine switch to crank the
engine. If the glow plug indicator light
comes on, the engine will start automati-
cally after the glow plug indicator light goes
off or 10 seconds past.
:DUPHQJLQH
Crank the engine by pressing the engine
switch to change the ignition mode to
“START”.
&DXWLRQZKHQVWRSSLQJWKHHQJLQHZLWK
WXUERFKDUJHU
When stopping the engine after climbing or
high speed driving, let the engine idle for
about one minute or more (if it is not pro-
hibited) to cool down the turbocharger and
engine oil. This is to prevent the engine oil
from over-deteriorating. Deteriorated
engine oil will damage the bearings of the
turbocharger.
5HVWDUWLQJ GLHVHO HQJLQH DIWHU IXHO
HPSW\VWRS
If the engine stops and the low fuel warn-
ing light and the malfunction indicator light
come on, use the following procedure:
1) Fill the fuel tank.
2) Press the engine switch to change the
ignition mode to “ON” for 5-10 seconds
to feed fuel.
3) Perform above engine starting proce-
dure to start the engine.
If the malfunction indicator light still comes
on after the engine started, there may be
some problem with the engine. Ask your
DXWKRULVHG0DUXWL6X]XNLZRUNVKRS
to have
the engine inspected.
,IWKH0$67(5:$51,1*LQGLFDWRUOLJKW
EOLQNVDQGWKHHQJLQHFDQQRWEHVWDUWHG
Your keyless push start system remote
controller may not be sensed as being
within the interior workable area. Try again
after making sure that you have the remote
controller with you. If the engine still can-
not be started, the battery of the remote
controller may be discharged. You must
then use the following method to be able to
start the engine.
58MST0302
1) Make sure the parking brake is set fully.
2) Shift to “N” (Neutral) and fully depress
the clutch pedal. Hold the clutch and
brake pedals fully depressed.
3) The “PUSH START SWITCH.” mes-
sage will appear on the information dis-
play in the instrument cluster. Press the
engine switch (1).
4) Within about 10 seconds of blinking of
the “MASTER WARNING” indicator
light in the instrument cluster, touch the
engine switch with the lock button end
of the remote controller (2) for about 2
seconds.
NOTE:
• If you still cannot start the engine after
several attempts using the above
NOTICE
'R QRW FUDQN WKH HQJLQH IRU PRUH
WKDQVHFRQGVDWDWLPH
,IWKHHQJLQHGRHVQ¶WVWDUWRQWKHILUVW
WU\ZDLWDERXWVHFRQGVEHIRUHWU\
LQJDJDLQ
(1)
(2)
(;$03/(