2-33
ELECTRIC STARTER SWITCH “
”
3
This switch is used for operating the
starter motor. With the ignition switch
in the “ON” position, the engine stop
switch in “
” and the transmission in
neutral, squeeze the clutch lever and
push the electric starter switch to start
the engine.
NOTE: This motorcycle is equipped
with an interlock system for the igni-
tion circuit and the starter circuit. The
engine can only be started if:
•
The transmission is in neutral and
the clutch is disengaged, or
•
The transmission is in gear, the
side stand is fully up and the
clutch is disengaged.
NOTE: The headlight will go off when
the electric starter switch is pushed.
LAP TIME COUNTER SWITCH
4
To change the display, push the lap
time counter switch. Refer to the
INSTRUMENT PANEL section for
detail.
THROTTLE GRIP
5
Engine speed is controlled by the
position of the throttle grip. Twist it
toward you to increase engine speed.
Turn it away from you to decrease
engine speed.
NOTICE
Engaging the starter motor for
more than five seconds at a time
can damage the starter motor and
wiring harness from overheating.
Do not engage the starter motor
for more than five seconds at a
time. If the engine does not start
after several attempts, check the
fuel supply and ignition system.
Refer to the TROUBLESHOOTING
section in this manual.
Содержание GSX-R1000/A
