58
NOTE:
There is a spare plastic lock plate for temporary
use only. Remove it from the cord and place in
a safe place on the boat. However, the original
cord and lock plate should be replaced as soon
as possible.
8
WARNING
Failure to properly attach the emergency stop
switch cord or to take proper precautions to
help ensure that the emergency stop switch
works as intended may result in serious injury
or death to the operator or passengers.
Always take the following precautions:
• Make sure that the emergency stop switch
cord is fastened securely to the operator’s
wrist or to an appropriate clothing area (belt
etc.).
• Ensure that no obstructions impede or
restrict emergency stop switch operation.
• Be careful not to pull the stop switch cord
or knock out the lock plate during normal
operation. The motor will stop abruptly, and
the loss of forward motion may unexpect-
edly throw occupants forward.
STARTING THE ENGINE
NOTE:
If the emergency stop switch lock plate is not in
position, the starter motor cannot operate.
1. Squeeze the fuel line priming bulb several
times until you feel resistance.
2. If equipped with Keyless Start System:
(1) Confirm that the keyless fob is in communi-
cation ON mode (Refer to the “Switching the
Communication mode of the keyless fob”
section.) Check that the keyless fob is within
communication range with the keyless con-
trol unit.
(2) Quickly press the engine switch to set Key-
less Start System to ON state (buzzer
sounds once) and automatically start all
engines.
8
WARNING
Exhaust gas contains carbon monoxide, a
dangerous gas that is difficult to detect
because it is colorless and odorless. Breath-
ing carbon monoxide can cause death or
severe injury.
Never start the engine or let it run indoors or
where there is little or no ventilation.