Suzuki Baleno, Руководство пользователя

Страница: 85 / 468

2-66
BEFORE DRIVING
68PM2-01E
Driving range
If you selected driving range the last time
you drove the vehicle, the display indicates
“ --- ” for a few seconds and then indicates
the current driving range when the ignition
switch is turned to “ON” position.
The driving range shown in the display is
the approximate distance you can drive
until the fuel gauge indicates “E”, based on
current driving conditions.
When the low fuel warning light comes on,
the display “---” will appear.
If the low fuel warning light comes on, fill
the fuel tank immediately regardless of the
value of driving range shown in the display.
As the driving range after refueling is cal-
culated based on the most recent driving
condition, the value is different each time
you refuel.
NOTE:
• If you refuel when the ignition switch is in
“ON” position, the driving range may not
indicate the correct value.
• When you reconnect the negative (–)
terminal to the battery, the value of driv-
ing range will be shown after driving for a
while.
Oil indicator
If either of odometer reading or time is
reached to the value which is set by the oil
life monitoring system, the oil change
request light comes on when the ignition
switch is in “ON” position. The “Oil” indica-
tion is shown on the Information Display
(C) to tell you it is necessary to change the
engine oil and oil filter.
68PM00269
For instructions on how to change the
engine oil and filter, refer to “Changing
engine oil and filter” in “INSPECTION AND
MAINTENANCE” section or consult your
SUZUKI dealer for advice on appropriate
procedure of engine oil and oil filter main-
tenance.
To monitor the next oil and oil filter change
timing properly, it is necessary to reset the
odometer reading and the time for the
light. The light will go out after the reset.
For the resetting procedure, it is recom-
mended to consult your SUZUKI dealer. If
you reset it by yourself, follow the proce-
dure described below:
To reset the engine oil life monitoring sys-
tem:
1) Turn the ignition key to “ON” position.
2) Push and hold the indicator selector
knob (2) for a while when the display
shows the oil change request light and
oil indicator.
68PM00270
EXAMPLE
(2)
EXAMPLE