Suzuki 2006 GSR600, Руководство по обслуживанию

Страница: 188 / 230

FI SYSTEM DIAGNOSIS 4-35
5) If OK, then check the continuity between each terminal and
ground.

CKP sensor continuity:
∞ Ω
(Infinity)
(Black – Ground)
(Green – Ground)
Are the resistance and continuity OK?
6) After repairing the trouble, clear the DTC using SDS tool.
(

4-26)
Step 2
1) Crank the engine a few seconds with the starter motor, and
measure the CKP sensor peak voltage at the coupler.
2) Repeat the above test procedure a few times and measure
the highest peak voltage.

CKP sensor peak voltage: 0.5 V and more
(
+
Black –
-
Green)
1
Peak volt adaptor

09900-25008: Multi-circuit tester set

Tester knob indication: Voltage (

)
.
Is the voltage OK?
3) After repairing the trouble, clear the DTC using SDS tool.
(

4-26)
YES Go to step 2.
NO Replace the CKP sensor with a new one.
YES
• G/W or G/BI wire open or shorted to ground.
• Loose or poor contacts on the CKP sensor cou-
pler or ECM coupler (terminal
D
or
U
).
• If wire and connection are OK, intermittent trou-
ble or faulty ECM.
• Recheck each terminal and wire harness for
open circuit and poor connection.
• Replace the ECM with a known good one, and
inspect it again.
NO
• Inspect that metal particles or foreign material
stuck on the CKP sensor and rotor tip.
• If there are no metal particles and foreign mate-
rial, then replace the CKP sensor with a new
one.
1
2
V
ECM couplers (Harness side)
2