Sutron XPert, Примечание к применению

Страница: 21 / 22

APPLICATION NOTE
TELULAR SX5 SERIES PHONE CELL & XPERT2/9210B SPEECH MODEM (OR 8210-3014 MODEM)
19
Figure 18. 8210 to speech modem to FWT conections
9.3 FWT Configuration
Configure the FWT (in this example a SX5T VERIZON modem) for data mode with the following
commands. A telephone handset must be connected to the SX5T device on the marked RJ11
jack. For the following commands refer to Page 16 of the SX5T user Manual.
Enter # * 6 # - This will place the SX5T in data always mode. Note, you do not have to be
in configuration mode to enter this command.
Enter configuration mode for the following commands. The lock code default is the last
4 of the 10 digit assigned telephone number unless it has been changed by the user.
Enter # * 0 * (Lock Code) # to enter configuration mode. Typically the last 4 digits of the
phone number are the Lock Code unless changed by the user.
Enter # * 113 * 1 * 0 # to select data port RJ-11.
Enter # * 136 * 2 # to SX5T for circuit-switched data at 19200 bps.
At this point the data transfers will be done via the serial data modes of the modems.