APPLICATION NOTE
TELULAR SX5 SERIES PHONE CELL & XPERT2/9210B SPEECH MODEM (OR 8210-3014 MODEM)
17
RIGHT arrow once so SERIAL: USER is visible,
Press the SET key until EXT MODEM is visible,
Press the DOWN arrow once and verify USER RATE: 9600 is visible. If not then press SET until
baud rate cycles to 9600.
Press the DOWN arrow until ENTER REQD: OFF is visible.
Press the SET key once to turn ON this option.
Press the ON/OFF key once.
The 8210 is now configured.
9.2 9210 Voice Modem configuration
Perform/verify the following to configure the XPert 8080-0005-1 modem.
Remove the gray cover and verify the internal jumpers are set as follows:
J5-- 2 to 3
J7—1 to 2
J3—1 to 2
This sets the input power to come from ex12 volts from the small green terminal
strip. Note the markings on the terminals. Verify power to the modem is OK with a DVM.
Do the following to program the speech settings on the XPert modem.
Using the standard serial cable connect from the PC male COM port to the modem DB9
female connector WITHOUT the NULL MODEM adapter.
Use a program like HyperTerminal to establish communication with the modem.
Set HyperTerminal to: 8 bits, No parity, 1 stop bit, 9600 bps.
Press the ENTER key a couple of times to set the modem to 9600 bps.
Type AT&V.
The current active profile will be shown as below.
ACTIVE
PROFILE:
B1 E0 L1 M1 N0 Q1 T V1 W0 X4 Y0 &C1 &D0 &G0 &J0 &K3 &Q5 &R1 &S0 &T5 &X0 &Y0
S00:001 S01:000 S02:043 S03:013 S04:010 S05:008 S06:002 S07:050 S08:002 S09:006
S10:014 S11:095 S12:050 S18:000 S25:005 S26:001 S36:007 S38:020 S46:138 S48:007
S95:000
STORED PROFILE 0:
B1 E0 L1 M1 N0 Q1 T V1 W0 X4 Y0 &C1 &D0 &G0 &J0 &K3 &Q5 &R1 &S0 &T5 &X0
