background image

a. Raise boat

Hoist in a series of pulls. Pull Single Black/Yellow 

Hoisting Rope (F) straight down. 

Diagram 21.

 Locked (left): Single Black/Yellow Hoisting 

Rope (F) pointed straight down locks cleat. Open (right): 

Angled rope opens cleat.

LOckED:  

Rope (F) down

OPEN:  

Rope (F) angled

b. stoRe boat

With boat in raised position make sure Single Black/Yellow 

Hoisting Rope (F) is securely locked in cleat with rope 

pointed down (see Diagram 21). Coil loose rope end.  

Hang coiled rope for storage when system is not in use.

Tip: For additional security, use two 5/16" (8 mm) 

polyester safety ropes. Securely tie ends to pigtail lag 

screws under boat, parallel with Webbing Straps (E). 

Remove safety ropes before lowering boat.

c. loWeR boat

Securely grip rope, apply tension and angle it away 

from front wall. Bring arm up to let rope out and then 

back towards the wall to lock the rope. Repeat until  

boat is at desired height.

steP 6:  oPeRating hoisteR system

LOckED

LOWERINg:  

(Cleat Open)

WARNINg! Disable garage door opener when 

installing, raising, or lowering the Hoister. Do 

not raise or lower with anyone standing under 

boat. keep area below Hoister clear. If the  

load falls it may cause an accident, damage  

to property, personal injury or death.

Tip: Use gloves to protect hands.

WARNINg! Hang coiled rope where it will not  

accidentally snag on persons or vehicle. keep 

coiled rope out of reach of children. Damage or 

injury may result if rope is angled away from wall 

with some tension; the boat can come down very 

quickly which may cause an accident, damage  

to property, personal injury or death.

WARNINg! When operating system, make sure 

area below boat is clear of persons. If boat 

comes down too quickly this may cause an  

accident, damage to property, personal  

injury or death.

WARNINg! Stop pulling as soon as boat contacts 

ceiling or webbing strap knots stop at pulley (D). 

Damage or injury may result from forcing the 

system. If in doubt, stop hoisting, allow cleat to 

lock by angling rope down. Stand back to see if 

boat is raised to the maximum or if something  

is jamming rope or boat.

cAUTION! Avoid injury, do not let rope slip  

through hands. Angle rope to wall to lock rope.

WARNINg! This product is not to be used for  

human suspension. components may fail  

causing person to fall, possibly resulting  

in serious injury or death.

With rope pointed down the cleat will lock the rope  

and you can release it. Repeat until boat is at  

desired height.

Содержание 7801BSZ













Отзывы: