19
E N G L I S H •
User's manual
RESURFACING FENCE
The fence can be resurfaced or made flat with
a jointer to correct any warping. This proce-
dure should only be done if the fences will not
align with each other after careful adjustment
or they are warped.
To resurface the fence, do these steps:
1. Make sure the fence face mounting screws
are far enough below the surface of the fence
that they will not contact the jointer knives
during operation.
NOTE: New fence faces can easily be made
out of hard wood and resurfaced by using this
same procedure.
2. Align both fence faces as straight as possible,
using a straightedge or your jointer table as an
alignment guide.
3. Resurface the fenc-
es on the jointer, as
shown in figure 21.
Fig.21
VOLTAGE - FREQUENCY
SPINDLE DIAMETER
SPINDLE SPEED
TABLE OPENING DIA.
WORKING TABLE
TABLE HEIGHT
POWER
CURRENT
WEIGHT
120 V ~ 60 Hz
1/2" (12,7 mm)
8 500 r/min
40 mm
452 mm x 395 mm
88 cm
750 W (1 HP)
5,3 A
73 kg (161 lb)
TECHNICAL DATA
TR701A manual.indd 19
28/05/15 10:27
