Surround Air XJ-3800, Инструкция по эксплуатации, Страница: 9 / 14

Cleaning and Maintenance
Cleaning and Maintenance of Plasma Dust Collector Grid
It’s time to clean when:
l The “Clean Metal Grid” indicator is glowing or blinking.
l The metal dust collector grid is making a zapping sound.
l
The air purifier has been out of use for awhile.
1
. Remove the front filter and the plasma dust collector grid.
2 . Lift up the tab at the top of the plastic housing for the
metal dust collector gird. Once this tab is open, remove
the dust collector. Please wear protective gloves to avoid
any cuts on your fingers.
3 . Clean the plasma dust collector:
l Use dish detergent.
l
Use a scouring pad or toothbrush to clean the dust collector.
l Use warm water.
4
. Cleaning the discharge wire:
l Gently wipe any dust build-up on the wires with your fingers
l If it is hard to eliminate all dirt, presoak with diluted detergent and
then use a toothbrush to scrub.
l Please beware not to damage any wiring while cleaning the dust
collector.
l If any electrical discharge wire is broken, the device will lose part
of or all of its dust collecting function.
l
Any broken wire should be thrown away instead of being left inside
the unit. Otherwise, a short-circuit or high-voltage spark could occur. Also,
the circuit control of the device would be affected.
l Please contact Surround Air for additional electrical discharge wire.
l Please do not clean using acidic or alkaline detergent that can create rust
on the surface of the device.
5 . Thoroughly clean and dry:
l
After cleaning, please completely dry the unit before use. Otherwise, it could
cause electrical shock or malfunction.
l If the front cover of the plasma dust collector is not properly installed, no
electricity will be connected.
l Please make sure the plastic wrap for the electrical discharge wire is located
at its proper position.