WARRANTY
The manufacturer warrants this product against defects in materials and workmanship for two (2)
years from date of purchase. If within this period a product is found to be defective in material or
workmanship, the product must be returned with a copy of the bill of sale as proof of purchase to
the manufacturer. This warranty does not cover the product becoming defective due to misuse,
accidental damage, improper handing and/or installation and specifically excludes liability for direct,
incidental or consequential damages. As some states do not allow exclusions or limitations on how
long an implied warranty lasts, the above exclusions and limitations may not apply to you. This
warranty gives you specific rights and you may also have other rights which vary from state to state.
For warranty service, call +1 (866) 870-9930, 9 a.m. - 5 p.m., EST, Monday - Friday.
TWO YEARS LIMITED WARRANTY
Printed in China
www.surfacemaxx.com
5
MAINTENANCE
4. Using a wrench (not provided) remove the nozzle
from the spray bar.
5. Using a straightened paper clip, free any foreign
material clogging or restricting the nozzle. (See
Figure 2)
6. Flush debris out of the nozzle. Direct the flow of
water through the nozzle backwards from the
outside to the inside.
7. Attach the wand back to the cleaner, set the
cleaner on a flat surface. Turn on the water
(DO NOT START THE PRESSURE WASHER)
and squeeze the trigger on the gun. Allow water
to run through the spray bar for approximately
30 seconds.
2
Spray bar
Nozzle
Straightened
paper clip
3
Spray bar
Nozzle opening
8. Reinstall the nozzle to the spray bar. Tighten securely.
Align the nozzle opening as shown in Figure 3.
Note:
After tightening securely, nozzle opening should
be pointed in same direction as spray bar.
Note:
If your spray pattern begins to change, it could
mean that the nozzles are worn and they will
need to be replaced.
