4
www.surfacemaxx.com
a. Starting with part F, feed hose into the locking
end of the smallest wand section E and feed the
hose through the tube.
b. Slide wand section E over wand section F all the
way up to the bottom of the adjustable head and
then push down on the lock lever.
c. Feed the hose into the locking end of wand
section D and feed the hose through the tube.
Slide wand section D over wand section E all the
way up and push down on the lever to lock.
d. Repeat the previous step with remaining
sections C, B and A.
2. Screw on the hose fitting into the water outlet and
tighten it clockwise.
3. Pivoting and locking construction for 3 position
angle adjustable with 20 - 40 - 60 degrees by
loosening the lock nut and sliding it towards the
wand. Once it is in the desired position, slide the
nut away and tighten.
1. To assemble the 6 sections of the telescoping wand:
ASSEMBLING THE TELESCOPING WAND
Unlock
NOTE:
For easier assembly, lay each wand section
out on the ground from smallest to largest before
beginning. Take care to avoid kinking the hose
during assembly. Make sure the lock levers are
unlocked prior to assembling. To unlock pull up on
the base of the lock lever.
See Figures 1 - 3.
Lock
Unlock
Lock
Lock
Unlock
2
Hose
Water
outlet
3
Lock nut
1a-d
Hose
Lock lever
E
Lock lever
Lock lever
Lock lever
Lock lever
F
Hose
D
E
Hose
C
D
Hose
B
C
Hose
A
B
