3
Quad 500 Face Shield
Assembly, Operating, and Maintenance Instructions
ENGLISH
Window Assembly
1.
Insert the top corner of the window on to the crown tab located in the image below, repeat for the
other side. Be cautious not to apply excess force that may break the corner tabs of the window.
2.
Press release tab on the inside of the crown while pushing the bottom of the window towards the crown.
3.
Using both hands, pull the side frame of the face shield to secure the window inside the side tabs.
Repeat for the other side of the window. The window must be secured by the (3) face shield frame inner
tabs on both sides per image (4).
4.
Carefully pull the face shield chin guard using both hands to secure the window to the bottom (2) chin
guard tabs. Verify the bottom of the window is properly secured between the chin guard tabs as per
image (6).
5.
NOTE: Before using make sure the Locking Tabs identified in the image are fully engaged!
Insert the top corner
of the window in-to
the crown tab.
Window
Locking
tabs
1
5
2
3
4
Press release tab to secure
the window to the crown.
Push window
towards crown
PULL
PULL
PULL
PULL
1
2
3
Flip Front Removal and Replacement
Flip Front Removal
1.
Remove the head gear knob on both sides of the face shield.
If the face shield has Hard Hat Interchange System Slotted
hard hat adapters (HHIS), remove the hard hat slot adapter
knob on both sides of the face shield.
2.
Remove the Flip Front visor and
replace with an approved
Jackson Flip Front.
3.
Place the new Flip Front Visor on
the crown and install the head
gear knobs on both sides of the
face shield. Verify both knobs
are properly secured before
using the face shield.
