Surefire BMS-350, Инструкция по установке и эксплуатации

Страница: 32 / 56

32
PILOTLESS OPERATION
Ignition Process - Pilotless
1) Unlock system
2) Set desired parameters
3) Press the ON button
4) Pre-purge - 60 second countdown displayed -
Green LED ON
5) Audible Alarm - 5 second countdown displayed -
Green LED ON
6)
Igniter - 8 second countdown displayed -
Green and Amber LED ON
7) Stage 1 Solenoid/Actuator valve opens - igniter remains on -
Green, Blue, and Amber LED ON
8) Ignition is achieved, flame is sensed -
Green and Blue LED ON
9) Unit is now running - Status code 00 - Green and Blue LED ON
10) Process temp exceeds High Temp Set point - Stage 1 solenoid valve closes -
Green LED ON
11) Process Temperature reduced to Low Temp Set point -
Restart at step 5

On a pilotless system, the Stage 2 Solenoid is not used.
Re-Ignition Process - No Flame Sensed
1) Once the system recognizes that no flame is sensed, the system will automatically begin the ignition
process.
2) Purge between ignition attempt - 120 second countdown -
Green LED ON
3) Reference step 5 - 10 in the “Ignition Process Section”
NOTE: If system fails to prove a flame on the fourth attempt, the system shuts down on code 12.
Blinking Red LED
Re-Ignition Process - Standby
1) System in Standby -
Blinking Green LED
2) Once the system resolves the Standby issue, the system will automatically begin the ignition process.
2)
Pre-purge on Start-up - 120 second countdown -
Green LED ON
Reference step 5 - 10 in the “Ignition Process Section
Re-Ignition Process - Shutdown
1) The system requires manual reset in the event of a shutdown.
2) System in Shutdown -
Blinking Red LED
3)
Once the Shutdown issue is resolved, manual reset is required. Press the OFF and ON button to reset.
4)
Pre-purge on Start-up - 120 second countdown -
Green LED ON
5) Reference step 5 - 10 in the “Ignition Process Section”
NOTE: Keep Pilot Mode in Mode 1 when application calls for PILOTLESS.