Shakespeare Stream Marine Wireless Booster Kit
Shakespeare Stream Marine Wireless Booster Kit
8
Installation
Installation
sTep 4. ConneCT Cables
Use the 20 ft. of cable and route from outside antenna to the booster. Connect the cable from the outside
antenna to the connection marked OUTSIDE. Route the cable immediately down and away from the outside
antenna, not wrapped or draped near it. When securing the cable, be sure to remove any kinks or loops.
Next, route the cable from helm antenna to the connection marked INSIDE. Tighten the connections and
secure any loose cable.
sTep 5. ConneCT power
It is highly recommended to run the power line through a rocker switch or circuit breaker to ensure power is
not drawn when not in use.
The positive red and negative black wired end will connect to watercraft’s power supply - either battery,
ignition or fusebox - whichever is located most conveniently.
Connect the DC power cord to the booster.
•
When the power LED turns ON, the booster is ready for use.
•
The Alert LEDs flash up to 15 seconds to show the frequency band is operational.
Note: While the watercraft is in port, the alert light may flash green slowly. This means that the booster is
self-adjusting due to over-signal. The Shakespeare Stream auto adjusts the gain if there is a strong signal
like at the dock. Thus, the lights may flash green in
such situations.
Flashing will resolve, returning to full power once
you leave the dock.
If red alert LEDs appear, increased antenna separa-
tion is likely needed. For more information, see "LED
Indicators" on page 9.
* WARNING. This booster is rated for 5-15V input voltage. DO
NOT use the booster with a higher voltage power supply.
This can damage the booster and/or cause personal injury.
