SureCall, Inc | 1-888-365-6283 | [email protected] | www.surecall.com
9
Installation
Place the Booster
To install the booster to a wall, select a location that is near a working AC outlet. Use the supplied screws or
appropriate screws for surface of mounting location and drill through screw tab holes on booster (see
illustration) and mount the booster to a wall.
Next, connect the outside antenna and booster by connecting the open end of the 50 ft. cable leading from the
outside antenna to the port of the booster marked “OUTSIDE”.
Step 4: Connect to Power and Turn On
Connect the AC power cord to the booster and plug into a 110V AC power outlet. Once the booster has been
completely assembled, turn the booster’s power switch to ON.
Note: If the Power LED does not turn ON or the Alert LEDs continue to flash, see the “LED Indicators” on page 11
section.
Note: This booster is rated for 5-15V input voltage. DO NOT use the booster with a higher voltage power supply. This can damage the booster, cause personal injury,
and void your warranty.
This booster should not be used near open fire or flame. Storage and transportation: Store and place in non-extreme room-temperature and dry environment.
Power Jack
Power Switch
Connector to Inside Antenna
N connector to inside antenna
N connector to outside antenna
44
OFF
54
64
44
OFF
54
64
45
OFF
55
65
52
OFF
62
72
51
OFF
61
71
Screw tab holes for optional wall mounting
Booster Diagram
