12
Installing your Hardware
5. Connect the inside antenna cable to the signal booster connector marked
INSIDE.
Hand-tighten the connection.
6. Connect the AC power cord to the signal booster.
7. Connect the plug on the other end of the 110V AC power outlet.
8. Turn the booster’s power switch on.
Booster Hardware
The following image shows the key hardware components on the booster.
Refer to this image as you install your Fusion4Home-Max kit components.
The signal booster turns on automatically.
Note:
If the Power LED does not turn ON or the Alert LEDs continue to flash, (see PAGES 15-16).This booster is rated for 5-20V input
voltage. DO NOT use the booster with a higher voltage power supply. This can damage the booster, cause personal injury, and void your warranty
Power Jack
Power Switch
Connector to Inside Antenna
N connector to inside antenna
F connector to outside antenna
12
https://www.signalbooster.com | 1-855-846-2654 | [email protected]
