7
Figure 8
13)The connection of the Chair :Put the chair on the side of the main machine and the center of the
table .Using chair Connecting line to connect the main machine and the back of the chair.
2.Adjustment
1)Check whether the host place is smooth, adjustable screw host level.
2
）
Turn on the power switch, power indicator is on .
3)The workboard can revolve steadily and flexibly (the range is 90°).
4)Press the left and right keys of the swing arm, it can swing steadily and without noise (the range is 30°).
5)Press the up and down keys of the swing arm, it can swing steadily, without noise when lifting up and down
(the range is 20cm).
6) Press the light key, and it must run in good condition.
7) Check whether the chair is set on horizontal ground or not by adjusting the four floor mats. When lifting the
chair up & down, the chair runs steadily and without nose (the range is 20cm).
8) Check whether the power supply for the work board and chart projector are all right or not.
3.Test and use
1)Rotate the table 90 degrees anticlockwise. Patient can easily sit on the chair.
2)Rotate the table 90 degrees clockwise to the front of the patient to us the refractometer ,return t
o original when finished.
3)Turn on the power of the projector to check.
4)Turn on the arm switch, and let Specimens comprehensive instrument to the front of the patien
t, to adjust the height of the chair using the up and down switch to the right height to conform to the
right height of the Specimens comprehensive instrument ,the arm return to the original location when fin
ished.
5)Rotate the table 90 degrees anticlockwise., press the down key in the chair to down the extreme
lower to move the table easily.
6)Turn off the power
，
and pull out the power line for not using for a long time .
