Supero SuperWorkstation 7045A-3, Руководство пользователя

Страница: 25 / 120

Chapter 2: Server Installation
2-9
2-6 Checking the Drive Bay Setup
Next, you should check to make sure the peripheral drives and the SAS drives
and SCA backplane have been properly installed and all connections have been
made.
1. Accessing the drive bays
All drives can be accessed from the front of the server. For servicing the DVD-
ROM, IDE hard drives and fl oppy drives, you will need to remove the top/left
chassis cover. The SAS disk drives can be installed and removed from the front
of the chassis without removing any chassis covers.
2. Installing components into the 5.25" drive bays
To install components into the 5.25" drive bays, you must fi rst remove the top/
left chassis cover as described in the previous section. Refer to Chapter 6 for
details.
3. Installing a fl oppy disk drive
Refer to Chapter 6 if you need to reinstall a fl oppy disk drive to the system.
4. Check the SAS/SATA disk drives
Depending upon your system's confi guration, your system may have one or more
drives already installed. If you need to install SAS/SATA drives, please refer to
Chapter 6.
5. Check the airfl ow
Airfl ow is provided by four hot-swap 8-cm chassis fans working in conjunction
with an air shroud. The system component layout was carefully designed to
promote suffi cient airfl ow through the chassis. Also note that all power and
data cables have been routed in such a way that they do not block the airfl ow
generated by the fans. Keep this in mind when you reroute them after working
on the system.
6. Supplying power to the system
The last thing you must do is to provide input power to the system. Plug the
power cord from the power supply unit into a high-quality power strip that offers
protection from electrical noise and power surges. It is recommended that you
use an uninterruptible power supply (UPS). Finally, depress the power on button
on the front of the chassis.