Supero SuperWorkstation 7044A-8, Руководство пользователя

Страница: 37 / 124

Chapter 5: Advanced Serverboard Setup
5-3
Heatsink Installation*
1. Do not apply any thermal com-
pound to the heatsink or the CPU
die; the required amount has al-
ready been applied.
2. Place the heatsink on top of the
CPU so that the four mounting
holes are aligned with those on the
retention mechanism.
3. Screw in two diagonal screws
until snug (do not fully tighten the
screws to avoid possible damage to
the CPU). The screw in the other
two diagonal screws until snug.
4. Finish the installation by fully
tightening all four screws.
Figure 5-1. 604-pin PGA Socket: Empty and with Processor Installed
Warning!
Make sure you lift the lever completely when
installing the CPU. If the lever is only partly raised, damage
to the socket or CPU may result.
!
Lever
With processor installed
Triangle (pin 1)
Empty socket
Triangle locating pin 1
*Note: This heatsink (SNK-P0010) is a passive heatink. It is an optional part that
must be purchased separately.