Supero SuperWorkstation 7044A-8, Руководство пользователя

Страница: 20 / 124

2-4
S
UPER
W
ORKSTATION 7044A-82/7044A-8/7044A-i2/7044A-i Manual
2-4 Installing the System into a Rack
This section provides information on installing the system into a rack unit. Rack
installation requires the use of the optional rackmount kit [CSE-PT26(B)]. If the
system has already been mounted into a rack or if you are using it as a tower,
you can skip ahead to Sections 2-5 and 2-6. There are a variety of rack units
on the market, which may mean the assembly procedure will differ slightly. The
following is a guideline for installing the workstation into a rack with the rack rails
provided in the rackmount kit. You should also refer to the installation instruc-
tions that came with the rack unit you are using.
Identifying the Sections of the Rack Rails:
The optional rackmount kit (CSE-PT26 or CSE-PT26B - black) includes two rack
rail assemblies. Each of these assemblies consist of three sections: an inner
fixed chassis rail that secures to the chassis, an outer rack rail that secures
directly to the rack itself and two rail brackets, which also attack to the rack (see
Figure 2-1.) The inner and outer rails must be detached from each other to
install.
To remove the inner chassis rail, pull it out as far as possible - you
should hear a "click" sound as a locking tab emerges from inside the rail
assembly and locks the inner rail. Depress the locking tab to pull the
inner rail completely out. Do this for both assemblies (one for each side).
Figure 2-1. Identifying the Sections of the Rack Rails
Inner rail
Outer rail
Rail brackets