Supero SuperServer 6041G, Руководство пользователя

Страница: 41 / 114

Chapter 5: Advanced Motherboard Setup
5-7
5-5 Processor Installation
When handling the processor package, avoid
p l a c i n g direct pressure on the label area of the fan.
This section covers the installation procedure for 370-pin socket proces-
sors. You should install the processor first and then install the mother-
board in the chassis. Following the installation procedures in the order they
appear in this section should eliminate the most common problems encoun-
tered when installing a system.
IMPORTANT: Always connect the power cord last and always remove it
before adding, removing or changing any hardware components.
!
Heatsink
Follow the instructions that came with your processor or heatsink to attach
a heatsink to the processor. Your heatsink should have a 3-pin fan, which
connects to the CPU FAN header. Make sure that good contact is made
between the CPU chip (the die) and the heatsink. Insufficient contact or
improper types of heatsinks, thermal compound or fans can cause the pro-
cessor to overheat, which may crash the system. (You can check the CPU
temperature readings in the "Periperal Setup" Section of BIOS.)
Processor
Your motherboard has two 370-pin sockets, which support Intel FCPGA
processors. Lift the lever on the socket and insert the processor with the
notched corner oriented toward pin one on the socket. Make sure the
processor is fully seated in the socket and and then close the lever. You
can also install a single 370-pin CPU in CPU Socket 1 without changing any
jumper settings. See Figure 5-3 for views of the 370-pin socket before and
after processor installation.
Mounting the Motherboard in the Chassis
All motherboards have standard mounting holes to fit different types of
chassis. Make sure the location of all the mounting holes for both the
motherboard and the chassis match. Although a chassis may have both
plastic and metal mounting fasteners, metal ones are highly recommended
because they ground the motherboard to the chassis. Make sure the metal
standoffs click in or are screwed in tightly. Then use a screwdriver to
secure the motherboard onto the motherboard tray.