Supero SuperServer 6041G, Руководство пользователя

Страница: 23 / 114

Chapter 2: Server Installation
2-7
2-5 Checking the Motherboard Setup
After you install the 6041G in the rack, you will need to open the unit to
make sure the motherboard is properly installed and all the connections
have been made.
1. Access the inside of the 6041G (see Figure 2-5)
First, release the retention screws that secure the unit to the rack.
Next, release the two thumbscrews that secure the top cover to the
chassis. Grasp the two handles on either side and pull the unit
straight out until it locks (you will hear a "click"). There are two
square recesses in the top cover to help you push the cover away
from you until it stops. You can then lift the top cover from the
chassis. You now have full access to the inside of the server.
2. Check the CPUs (processors)
You should have one or two processors fully inserted into the system
board. If one CPU is used, install the CPU into CPU Socket 1 (see
Chapter 5). Inadequte ventilation or improper installation of the CPU
heat sinks may result in the instability of the system. When installing
the heat sinks, use the proper type of thermal glue and apply the
proper amount of thermal glue on the die of the CPU. improper type or
amount of thermal glue used on the die of the CPU and improper
installation of the heat sink may result in the crash of the system.
3. Verify the proper CPU core/bus ratio setting
You need to verify that the CPU core/bus ratio as set with DIP Switch
1 matches the speed of your installed processors. This DIP Switch is
defaulted to 5.5, which corresponds to 550 MHz processors running
on a 100 MHz front side bus (FSB). If the setting is different or if you
are using processors of a different speed, you may need to change
this setting.
4. Check all cable connections and airflow
Make sure all power and data cables are properly and firmly connected
and not blocking the airflow.