Supero SuperServer 6033P-8R, Руководство пользователя

Страница: 51 / 114

Chapter 5: Advanced Serverboard Setup
5-15
Extra Universal Serial Bus
Headers
Extra USB headers (USB2/USB3)
can be used for front side USB
access. You will need a USB
cable (not included) to use either
connection. Refer to the tables on
the right for pin definitions. An ad-
ditional header (USB4) designated
J27 is located near the Chassis Fan
3 header. Note : USB4 is not a
Legacy-supported header, meaning
any device attached to it will not oper-
ate outside of the operating system.
Pin
Number
2
4
6
8
10
Definition
Power
-
+
Ground
Key
USB2 Pin
Definitions (J13)
Pin
Number
1
3
5
7
9
Definition
Power
-
+
Ground
Key
USB 3 Pin
Definitio ns (J14)
ATX PS/2 Keyboard and
PS/2 Mouse Ports
The ATX PS/2 keyboard and PS/2
mouse are located on J9. See the
table at right for pin definitions.
(See Figure 5-4 for the locations of
each.)
PS/2 Keyboard
and Mouse Port
Pin Definitions
(J9)
Pin
Number
1
2
3
4
5
6
Definition
Data
NC
G round
VCC
Clock
NC
Serial Ports
The COM1 serial port is located un-
der the parallel port (see Figure 5-4).
See the table on the right for pin
definitions. The COM2 connector is
a header located near the PCI-X #1
slot on the serverboard.
Serial Port Pin Definitions
(COM1, COM2)
Pin Number Definition
1 CD
2 RD
3 TD
4 DTR
5 Ground
Pin Number Definition
6 DSR
7 RTS
8 CTS
9 RI
10 NC
GLAN1/2 (Ethernet Ports)
Two Ethernet ports (designated
GLAN1 and GLAN2) are located
beside the VGA port on the IO back
plane. These ports accept RJ45 type
cables.
Note: Pin 10 is included on the header but not on
the port.